Carolina Shooters Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
816 Posts
Discussion Starter · #1 · (Edited)
I know people rant against shooting other peoples handloads, ect so I will go into great detail and list the equipment and steps used and let the buyer decide.
I start with once fired Federal brass.
Brass is tumbled in lizzard litter with non amonia polisher.
Deprimed and full length sized with RCBS dies on RCBS press
Retumbled.
Case length is hand trimmed with ball cutter and checked with digital calipers, primer pockets cleaned, flash holes deburred and case mouths are chamfered inside and out.
reprimed with CCI-BR bench rest primers
Bullets are Sierra 168 gr BTHP #2200 Matchking and are sorted from 500 piece boxes to within .4 grain of 168.0 (acceptable are 167.8-168.2).
Load is from US ARMY TM match M852 manual and calls for IMR-4895, TM 43-0001-27. Specs produce ammo that is interchangable with Federal GM308m Gold Medal Match.
Powder is a single lot of IMR4895.
EVERY CHARGE IS HAND THROWN. EVERY CHARGE IS WEIGHED ON RCBS DIGITAL SCALE.
This is my weighing prosses. I weigh out the charge below say .03 of my goal. then I hand dribble until the scale bounces between the goal weight and .01 below. Wait and adjust by granual.
OAL 2.82

I have personally shot a .338" 5 shot group with this ammo.

$18 per 20
 

·
Registered
Joined
·
816 Posts
Discussion Starter · #4 ·
sorry. dont have any 175's.
And since I have been advised that I am not a federal licenced ammunition producer and that the ATF is gonna come whoop me up all WACO style for selling a couple hundred rounds of ammo... These are for components only. Yeah...These are sold for the sole purpose of the buyer breaking them down to use as components for reloading.
OK?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top