Anyone for bending some flats? | Carolina Shooters Club

Anyone for bending some flats?

Discussion in 'Gunsmithing | Firearm Assembly | Troubleshooting' started by pennywise, Jan 14, 2009.

  1. pennywise

    pennywise Registered Member

    Joined:
    Jan 25, 2008
    Messages:
    72
    Location:
    FT.Bragg nc
    Does anybody have the tools necessary to bend some flats and teach someone? I see alot of misc requests and some attempts but no follow through. I have two flats and zero experience. I also see there a few others in the same boat.

    Let's go for the 50m target and get some flats bent! Everyone else need not apply unless you want to learn. Someone with the tools and knowlege buck up and lets get this thing rolling! We need to spread this knowlege all over this state so a build party or a quickie on the weekend will not be such a pain in the ass! "That didnt come out right, but you know what I mean!

    I am close to SC and not far from Raliegh 1.5 hrs.
    I will be willing to pay for the knowlege.
     
  2. andyrv6av8r

    andyrv6av8r Registered Member

    Joined:
    Jul 29, 2007
    Messages:
    265
    I have the tools near Spartanburg, SC if you want to drive.
     

Share This Page